Driving to Your Destination
The destination icon only shows the
approximate location of the destination.
This occurs because a city block can
have as many as 100 possible addresses
(for example, the 1400 block is followed
by the 1500 block.) Since most cities
use only a portion of the 100 possible
addresses (for example, in the 1400
block, the addresses may only go up to
1425 before the 1500 block starts).
Therefore, an address if 1425 will be
shown a quarter of the way down the
block by the system instead of near the
end of the block where the destination
Landmark icons are shown in the map
screen on 1/20 and 1/8 mile scale, or 80
and 200 meter scale. The Freeway exit
information is displayed on the 1/4, 1/2,
and 1 mile scales. The icons are:
Freeway exit information
The same list can be viewed on the
screen by selecting Map Legend from
the Information screen.
Some icons can be turned on or off;
you can either display them or hide
them from the ICON button on the
lower left corner (see page 46) or using
voice commands (see page 118).
You can select most landmark icons
with the joystick to display the icon's
information. See the table on the
following page for exceptions.
• When there are overlapping
landmark icons, a list of the points of
interest (POIs) is displayed.
• For information of the available
voice commands, see Voice
Command Index on page 118.