Exposure System; Routing The Scanner Drive Cable - Canon NP6218 Service Manual

B. Exposure System

1. Routing the Scanner Drive Cable

Route the cable as shown by
position as described.
Screw
Loosen the
screw,and shift
it down.
Re-tighten
the screw.
Caution:
When attaching the wire spring, pay attention to the orientation of the spring; see
the diagrams below. If not attached correctly, its hook tip could interfere with the
cable.
COPYRIGHT © 1997 CANON INC.
through
Attach the mirror
positioning tool.
34±1mm
Figure 10-211
Wire spring
Hook
Cable
Figure 10-212
CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 10 TROUBLESHOOTING
; then, adjust the cable tension and mirror
Set screws
Loosen the set
screws to enable
free rotation.
Put the steel ball
into the hole in
the pulley; wind
the cable nine
times toward the
inside, and four
times toward the
outside; then, snap
on the pulley clip.
Hook
Cable
Wire spring
Pulley clip
Steel ball
10-15