Canon NP6218 Service Manual page 248

CHAPTER 8 INSTALLATION
6) Remove the slack from the cable between the copier and the RDD; keep the excess
cable to the RDD using the harness band
7) Shift bit 4 of the DIP switch 2
RDD and the copier is IPC mode.
8) If the ROM IC6
ON; otherwise, shift bit 7 of the DIP switch 2 to OFF.
Note:
1. If the ROM (IC6;
2. If you are mounting or replacing the ROM (IC6;
sure to shift bit 7 of the DIP switch 2
8-30
to ON so that the communication mode between the
LED1 LED2 LED3
LED5
LED6
LED4
IC6
SW1
is mounted on the RDD's PCB, shift bit 7 of the DIP switch 2
) is not mounted, you need not mount it.
COPYRIGHT © 1997 CANON INC.
.
Fig. 8-708
2 6
BAT1
1 1
1
SW3
SW2
SW4
2
CN4
CN3 CN2
Fig. 8-709
to ON.
CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
for upgrading the RDD, be
to