Dc Controller Pcb - Canon NP6218 Service Manual

F. DC Controller PCB
1. Detaching the DC Controller PCB
1) Disconnect the connector of the DC controller.
2) Remove the four screws
mount.
2. Points to Note When Replacing the DC Controller PCB
• When sending the DC controller PCB to the workshop or factory, put it in a conducting
bag while keeping it intact with the mount. Use a conducting bag whose one side is
transparent, and make sure that the face of the DC controller PCB shows through the
transparent side of the bag.
• After replacement, perform following; see p. 7-20:
enter the value recorded on the service label;
adjust the multifeeder paper width sensor;
adjust the intensioy of the scanning lamp; and
adjust AE.
COPYRIGHT © 1997 CANON INC.
, and detach the DC controller PCB together with its
Figure 7-224
CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS
7-17