Adding Trap Targets; Removing Trap Targets - HP Bc1500 - BladeSystem - Blade PC User Manual

Setting Up the System
To modify the system contact information using the CLI, type:
SET SNMP CONTACT <contact>
The <contact> field must be 0-20 characters long and supports all the alphanumeric characters,
the underscore, the dash, and spaces with quotes.

Adding Trap Targets

To add a trap target using the Web-based user interface:
1. Click the Enclosure tab.
2. Click SNMP Configuration in the left panel.
3. Type the IP address in the appropriate field of the SNMP area.
4. Click Add.
5. Click Apply.
To add a trap target using the CLI, type:
ADD SNMP TRAPRECEIVER <IP address>
The <IP address> must be in the form ###.###.###.###, where ### ranges from 0 to 255.
The Integrated Administrator only supports v1 traps and directs the traps to SNMP port 162 by
default. You can add a maximum of eight IP addresses to receive SNMP traps.

Removing Trap Targets

To remove a trap target list using the Web-based user interface:
1. Click the Enclosure tab.
2. Click SNMP Configuration in the left panel.
3. Type the list name in the appropriate field of the SNMP area.
4. Click Remove.
5. Click Apply.
To add or remove a trap target list using the CLI, type:
REMOVE SNMP TRAPRECEIVER <IP address>
The <IP address> must be in the form ###.###.###.###, where ### ranges from 0 to 255.
6-16 HP PC Blade Enclosure Integrated Administrator for CCI v1.4 User Guide