The default read community name is "public," and the default write community name is blank.
Modifying the System Location
NOTE:
The SNMP protocol can be disabled in the Network Configuration area of the Web-based user
interface.
To modify the system location information using the Web-based user interface:
1.
Click the Enclosure tab.
2.
Click SNMP Configuration in the left panel.
3.
Set the cursor in the System Location field and type the appropriate information.
4.
Click Apply.
To modify the system location information using the CLI, type:
SET SNMP LOCATION <location>
The <location> field must be 1-20 characters long and supports all the alphanumeric characters, the
underscore, the dash, and spaces with quotes.
Modifying the System Contact Information
To modify the system contact information using the Web-based user interface:
1.
Click the Enclosure tab.
2.
Click SNMP Configuration in the left panel.
3.
Set the cursor in the System Contact field and type the appropriate information.
4.
Click Apply.
To modify the system contact information using the CLI, type:
SET SNMP CONTACT <contact>
The <contact> field must be 1-20 characters long and supports all the alphanumeric characters, the
underscore, the dash, and spaces with quotes.
Adding Trap Targets
To add a trap target using the Web-based user interface:
1.
Click the Enclosure tab.
2.
Click SNMP Configuration in the left panel.
3.
Type the IP address in the appropriate field of the SNMP area.
4.
Click Add.
5.
Click Apply.
To add a trap target using the CLI, type:
ADD SNMP TRAPRECEIVER <IP address>
86
Chapter 6 Setting Up the System
ENWW