User Permissions - HP Bc1500 - BladeSystem - Blade PC User Manual

Setting Up the System
■
Configuring SNMP support
❏
Entering a community string
❏
Modifying the system location
❏
Modifying the system contact information
❏
Adding trap targets
❏
Removing trap targets
For a detailed explanation of the command line conventions used in this document, see Appendix
A, in section "Command Line Conventions."
These procedures are supported by the Web-based user interface and the CLI unless otherwise
noted.
✎
Most of these tasks are limited to a subset of users. For more information on who can perform
each task, see the "User Permissions" section and the section describing that task in this chapter.

User Permissions

The group-centered approach of Integrated Administrator to user permissions facilitates the
maintenance of user groups and groups of blade PC bays. This approach operates according to
the following principles:
■
A blade PC bay is assigned exclusively to one group only.
■
A group can be assigned many blade PC bays.
■
A user can have various permission levels within any number of groups.
■
Access to a blade PC by users or groups depends on the rights assigned to the blade PC bay
in which the blade PC is installed.
Use the following table to distinguish the various permission levels available from the HP PC
Blade Enclosure Integrated Administrator.
6-2 HP PC Blade Enclosure Integrated Administrator for CCI v1.4 User Guide