Olivetti d-Color MF450 Reference Manual page 307

Box Operations
d-Color MF450:
Parameter
Sort
Group
Offset
Staple
Punch
Half-Fold
(Center Staple/ Fold)
Center Staple
(Center Staple/Fold)
!
Detail
The feeding method when a finisher is installed can be changed from Administrator mode.
When a Center Staple/Fold setting is selected, "Sort" is automatically selected, and the "Group",
Offset, Staple and Punch settings are canceled.
Reminder
In order to select a Center Staple/Fold setting, all of the following conditions must be met.
The paper width must be between 182 and 314 mm.
The paper length must be between 257 and 458 mm.
In order to use a Center Staple/Fold setting, optional finisher FS-519 must be installed.
d-Color MF550/MF450
Description
Select this setting to feed out copies of the document by sets.
Select this setting to feed out copies of the document by page.
Select this setting to separate the sets or pages of the copies.
If a finisher is installed, the printed pages are fed out with each set shifted to separate
it.
If no finisher is installed, the printed pages are fed out sorted in an alternating criss-
cross pattern.
Select one of these settings to bind copies with a staple in the corner (upper left or
upper right) or with two staples. The stapling position can also be selected.
Select a setting to punch holes in copies. The position of the punched holes can also
be selected.
Select this setting to fold copies in half before feeding them out.
Select this setting to staple copies at two places along the center before feeding
them out.
4
4-41