Olivetti d-Color MF450 Reference Manual page 150

2
7
Select the desired copy settings, and then press the [Start] key.
– To print a single copy to be checked, press the [Proof Copy] key.
– Repeat steps 6 and 7 until all documents have been scanned. The amount of memory available can
be checked beside "Memory" in the lower-left corner of the screen. In addition, the number of
document batches can be checked beside "Scanned Batches".
– When the memory is full, a message appears. Select whether to delete the last part of the data and
scan it again, delete the last part of the data and print, or delete all of the document data.
– To cancel changes to the settings, touch [Cancel].
Scanning begins. After scanning is finished, touch [Fix], and then touch [OK].
Is there more information about the settings?
?
% Refer to the appropriate section.
8
After all document pages have been scanned, touch [Finish].
A message appears, requesting confirmation that scanning is finished.
9
Touch [Yes], and then touch [OK].
– If "No" was selected, touch [Change Setting] to change the copy settings.
2-114
Copy Operations
d-Color MF550/MF450