To Assign Devices To Ports - AT&T OneVision DEFINITY G3 Guide Installation And Connection Manual

UnixWare Administration

To Assign Devices to Ports

To Assign Devices to
Ports
Introduction You need to assign devices (terminals and modems) to the ports
on your system so that the port monitors can recognize them.
When to use Assign devices to ports after you have installed UnixWare.
Procedure Use the following steps to assign a terminal or a modem to a port:
Step Action
1 Enter the following command at the UNIX prompt:
/usr/sbin/sysadm
Result: The OA&M Operations, Administration and
Maintenance menu displays.
2 Open the Quick Terminal Setup screen.
Hint: Select the following options to navigate through the
OA&M screens:
At this screen . . .
OA&M Operations,
Administration and
Maintenance
Service Access Management
Quick Terminal Setup
Select this option . . .
ports
quick-terminal
add
Issue 2 April 1996
4-15