To Validate Dial Strings - AT&T OneVision DEFINITY G3 Guide Installation And Connection Manual

Planning Connectivity

To Validate Dial Strings

To Validate Dial Strings
Introduction You must verify that the dial string in the /etc/uucp/Dialers file is
valid for your data communications hardware. If it is not, you need
to edit the Dialers file.
When to use Validate the dial string after you have connected your data
communications hardware to your Proxy Agent PC.
Dial strings The following table shows the valid dial string for your
communications hardware. The dial string in the Dialers file is on
one continuous line.
Communications
hardware
Modem
Data Module:
AT&T 7400B
Data Module
(PDM or MPDM)
or ADU
Dial string
hayes =,-, ""
\M\dAT&FE1V1X4Q0&C1&D2S7=255S0=
0\r\c OK \EATDT\T\r\c CONNECT \m
Use this dial string if you have a Serial I/O
ports card.
pdm =+ "" \M\K\p DIAL: \T
ANSWERED \p\c\m
Issue 2 April 1996
5-29