Table of Contents
Advertisement
Connectivity
To Program PBX Ports
Procedure 1:
To program the system port on the switch, use the add
System ports
data-module command.
Step
1
2
3
For system port cabling, typically port 1 of the data board is
cabled to port 1 of the pdata board.
Procedure 2:
Use the following steps to program an analog line with a modem.
Analog line
You must use modem pooling.
with modem
6-12
Issue 2 April 1996
Action
Enter the following command:
add data-module
Enter the following:
Field
For a G3r PBX ...
Type
system-port
Port
The data port
location
Associated
The port location of
PDATA
the associated
Port
pdata board
Use the add hunt-group command to add the system
port extension as a member of a hunt group.
For a G3i PBX ...
netcon
The data port
location
The port location
of the associated
p data board
End
Advertisement
Table of Contents
