Table of Contents
Advertisement
Serial I/O Cards
DigiBoard Xem
DigiBoard Xem
When to use
Use this section to install and administer the DigiBoard Xem
device driver.
Materials
needed
Installation
Before your begin the installation:
guidelines
Procedural
Complete the following procedures in the sequence shown.
overview
Hint: If you need help navigating through the installation software,
refer to your DigiBoard installation guide.
Root permission
The DigiWare installation diskette
The installation guide for the DigiBoard Xem System
Make sure your hardware is installed and all connections
are secure. (Use a DB-25 male cable.)
Set the DIP switch according to your hardware
configuration.
Write down the I/O port address. You'll need it during the
installation procedure.
Procedure 1: Install the device driver
Procedure 2: Configure the device driver
Procedure 3: Test the installation
Issue 2 April 1996
7-3
Advertisement
Table of Contents
Need help?
Do you have a question about the OneVision DEFINITY G3 Guide and is the answer not in the manual?