To Create Port Monitor Entries - AT&T OneVision DEFINITY G3 Guide Installation And Connection Manual

Serial I/O Cards

To Create Port Monitor Entries

To Create Port Monitor
Entries
Introduction The port monitor entry must contain the correct information to
support the way the port will be used.
When to use
Complete these procedures after you have installed the Serial I/O
card and verified that the Devices and Dialers files are set
correctly.
Procedural The following procedures explain how to administer the port that
overview receives alarms. Complete these procedures in the sequence
shown.
Procedure 1: Start at the UNIX prompt.
Open the
Port
Monitor
screen
7-18 Issue 2 April 1996
Procedure 1: Open the Port Monitor screen
Procedure 2: Enter port data
Procedure 3: Open the Port Services screen
Procedure 4: Enter port services data, page 1
Procedure 5: Enter port services data, page 2