Set The Modem Options For Alarm Forwarding - AT&T OneVision DEFINITY G3 Guide Installation And Connection Manual

Alarms

Set the Modem Options for Alarm Forwarding

Set the Modem Options
for Alarm Forwarding
Introduction This section describes how to set modem options for the AT&T
3715 modem that is certified for alarm forwarding.
Procedure Start at the UNIX prompt.
Step Action
1 Use a UNIX editor to open the following file:
etc/uucp/Devices
2 Add (or edit) the following line:
ACU term/a01m, - 1200 direct_modem
3 Write and quit the file.
4 Enter the following command:
cu -1 /dev/ttya01m
5 Enter the following to connect to the modem:
at
Result: The modem responds with an OK prompt.
6 Enter the following modem option.
AT&F
Result: The modem responds with an OK prompt. This
option sets the modem to its default setting. (The
required options are set in the Dialers script file.)
Issue 2 April 1996
End
10-15