Lucent Technologies MERLIN LEGEND Release 5.0 System Programming And Maintenance Manual page 22

MERLIN LEGEND Communications System Release 5.0
System Programming and Maintenance (SPM) 555-650-140
System Programming and Maintenance
Installing the SPM Software
Checks if the print.exe file is present in any directory listed in the PATH
environment variable.
Runs the DOS SETVER command to set the version table for print.exe to
6.22. This is required to enable print.exe to run on Windows 95.
Creates an spm.bat file in the directory c:\spm. The spm.bat file contains
the ams_path and print statements required to run SPM.
Unzips and copies the remaining files into the directory c:\spm.
Instructs you to refer to this document for details on using the PIF Editor
to configure an SPM PIF file to work with the spm.exe file.
Installation
With Windows 95 running on your PC, follow these steps to install SPM on the
PC's hard drive:
1. Insert a backup copy of SPM in any floppy disk drive (usually the A
drive).
2. Choose one of the following two methods to install SPM:
Method 1- Install DOS SPM with French, Spanish, or English
Language:
a. Open a DOS Window from the Windows Explorer.
b. At the DOS prompt, switch to the drive with the backup copy of
c. At the DOS prompt, type one of the commands shown below and
SPM diskette (usually the A drive).
press
P Â
instal95 or instal95 english
instal95 french
instal95 spanish
Issue 1
June 1997
Page 8