System Requirements - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming And Maintenance Manual

MERLIN LEGEND Communications System Release 5.0
System Programming and Maintenance (SPM) 555-650-140
System Programming and Maintenance

System Requirements

This book describes the use of SPM on a PC with a DOS operating system. If
your system has the Intuity or IS II/III application, you have the UNIX System
version of SPM.
For information about accessing SPM from the IS II/III application, refer to the
following books:
Integrated Solution III System Manager's Guide, order no. 555-601-010
Integrated Solution III Installation and Maintenance Guide, order
no. 555-601-011
Integrated Solution II System Manager's Guide, order no. 555-600-726
Integrated Solution II Installation and Maintenance Guide, order
no. 555-600-720
System Requirements
To use SPM for system programming, you need the SPM diskette and an
approved PC with version 3.3 (or later) of MS-DOS . At a minimum, your PC
should support and include the following items:
At least 640 kbytes of RAM
A floppy disk drive that will accommodate the SPM diskette (3.5-inch or
5.25-inch)
A monochrome or color monitor
A serial port that can use either a DB-9 or DB-25 connector
For a DB-9 connector, use a 9-pin to 25-pin adapter to attach the 25-pin
connector of the RS-232 interface cable.
An RS-232 interface cable of appropriate length for your site
connection(s)
Issue 1
June 1997
Page 2