Surrogate Mode Programming - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming And Maintenance Manual

MERLIN LEGEND Communications System Release 5.0
System Programming and Maintenance (SPM) 555-650-140
System Programming and Maintenance

Surrogate Mode Programming

Table 14. Programming Needed after Upgrade to Release 5.0
Feature
Group Calling Delay
Secondary
Announcement
Group Calling
Announcement
Interval
Group Calling Repeat
Announcement
Surrogate Mode Programming
Surrogate mode allows qualified service personnel to perform system
programming at an off-site service location. The actual communications system
hardware does not have to be installed—the programmer needs only a direct
connection from the PC to the processor module. By following a customer's set
of completed planning forms, the system can be programmed as if the
appropriate modules, trunks, and telephones have been installed. When
system programming is completed, a system backup is performed to save the
information on disk. This backup disk is then taken to the new installation site
and used with the Restore option to provide complete system programming for
a new communications system.
You do not "select" surrogate mode programming you enter it automatically
under the following conditions:
Sequence
More
Extensions
Calling DelayAnnce
no.
Enter Secondary Announcement
Exstenion number of Announcent device
Exit Exit
More
Extensions
Calling DelayAnnce
no.
Enter Announcement Interval
Announcent Interval in seconds
More
Extensions
Calling DelayAnnce
no.
Enter Repeat Announcement
No Enter Exit
Grp
Dial calling group ext.
Grp
Dial calling group ext.
Enter
Grp
Dial calling group ext.
Exit
Issue 1
June 1997
Page 89
– Continued
Enter
Enter
Enter
Exit Exit
or
Yes