Restore - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming And Maintenance Manual

MERLIN LEGEND Communications System Release 5.0
System Programming and Maintenance (SPM) 555-650-140
System Programming and Maintenance
Using SPM
SMDR Port Output
See "Printing System Reports" in Chapter 3 for more information about the print
procedure using the system console and the SMDR port.
PC Port Output
See ''Printing Reports''
SPM and the PC port.

Restore

The Restore option allows qualified service personnel to load system
programming from either a diskette or from the hard disk into the processor
module memory.
This procedure is used either to program a new system if a disk was created
through surrogate mode programming, or to restore information (using a
backup disk) lost through system failure. It is also part of the upgrade
procedure.
Considerations
Review the following items before you begin the restore procedure.
The system will be forced idle during a restore procedure.
You must have a backup file containing system programming before you
use this procedure. See ''Backup''.
Features that were not programmed when the backup file was created
are reset to factory defaults.
The data restored reflects the number of extensions and lines available
on the system at the time the backup was created. The remaining
extensions and lines are set to the default values that are initialized
during a Restart (cold start).
for more information about the print procedure using
Issue 1
June 1997
Page 58