Lucent Technologies MERLIN LEGEND Release 5.0 System Programming And Maintenance Manual page 26

MERLIN LEGEND Communications System Release 5.0
System Programming and Maintenance (SPM) 555-650-140
System Programming and Maintenance
Installing the SPM Software
The information you provide during the initialization process is written to the
SPM configuration file (ams.cfg). If you need to change this information at
some later time, you can do so in either of the following ways:
Use any of the options in
Edit the ams.cfg file. (If you are unsure about editing the file, you can
remove it. You are prompted to reinitialize the next time you invoke SPM.
The file is created at that time.)
NOTE:
The
DEBUG
default setting, or
Escape-to-Shell feature of SPM, activated by pressing
DEBUG on, you must edit the ams.cfg file; it is not part of the initialization
process. The DEBUG attribute is for use by qualified service personnel
only.
Table 1. SPM Configuration File (ams.cfg) Options
Option
spm -com1
spm -com2
spm -s1200
spm -s2400
spm -color
spm -mono
spm -1 english
spm -1 french
spm -1 spanish
Table 1
attribute is also specified in ams.cfg as
(on). This attribute is used to enable the
DEBUG=1
Use
Specifies COM1 as the serial communications port
used by SPM
Specifies COM2 as the serial communications port
used by SPM
Specifies modem speed of 1200 bps
Specifies modem speed of 2400 bps
Specifies color monitor
Specifies monochrome monitor
Specifies English as the PC language
Specifies French as the PC language
Specifies Spanish as the PC language
to change the information in ams.cfg.
DEBUG=O
Issue 1
June 1997
Page 12
(off), the

+ . To turn
5