Programming - AT&T MERLIN LEGEND Release 2.0 Equipment And Operations Manual

Introduction

Programming

System Programming
The system can be programmed with options for the following:
Basic system operating conditions
System renumbering
Settings for lines/trunks
Telephones and operator consoles
Adjuncts
Applications
Optional features
The system can be programmed by using one of the following:
An MLX-20L telephone connected to one of the first five ports on the first
MLX module in the control unit
The built-in modem in the processor, which permits remote programming
via the public network. For example, support personnel can access the
system by using a PC with a modem and with SPM software; support
personnel call the system and enter a password to gain access. The
system must be programmed for Remote Access.
A PC with SPM software connected to the lower RS-232 port on the
processor
The programming options are accessed from display screen menus. For more
information, see System Programming. To use SPM to program your system on
a personal computer, you need the SPM diskette and an PC with version 3.3 (or
a later version) of MS-DOS® .
Your PC should include the following:
At least 640 kbytes of random access memory (RAM)
A floppy disk drive that will accommodate the SPM diskette
A serial port that can use either a DB-9 or DB-25 connector
NOTE:
For a DB-9 connector, use a 9-pin to 25-pin adapter to convert the
25-pin connector to a modular connector.
Either a 355AF modular adapter (if a male connector is on the interface
cable) or 355A modular adapter (if the connector is female)
Programming
1-30