AT&T MERLIN LEGEND Release 2.0 Equipment And Operations Manual page 16

Hide thumbs Also See for MERLIN LEGEND Release 2.0:
Table of Contents

Advertisement

Customer Support Information
Allowing this equipment to be operated in such a manner as not to
provide proper answer supervision signaling is in violation of
Part 68 rules.
DOC Notification and Repair Information
NOTICE: The Canadian Department of Communications (DOC) label identifies
certified equipment. This certification means that the equipment meets certain
telecommunications network protective, operational, and safety requirements.
The DOC does not guarantee the equipment will operate to the user's
satisfaction.
Before installing this equipment, users should ensure that it is permissible to
connect it to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection.
In some cases, the company's inside wiring for single-line individual service
may be extended by means of a certified connector assembly (telephone
extension cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations
made by the user to this equipment, or any equipment malfunctions, may give
the telecommunications company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that the electrical ground
connections of the power utility, telephone lines, and internal metallic water pipe
system, if present, are connected. This precaution may be particularly
important in rural areas.
CAUTION: Users should not attempt to make such connections themselves, but
should contact the appropriate electrical inspection authority or electrician, as
appropriate.
To prevent overloading, the Load Number (LN) assigned to each terminal
device denotes the percentage of the total load to be connected to a telephone
loop used by the device. The termination on a loop may consist of any
combination of devices subject only to the requirement that the total of the Load
Numbers of all the devices does not exceed 100.
DOC Certification No. 230 4095A
CSA Certification No. LR 56260
Load No. 6
Renseignements sur la notification du ministère des Communications du
Canada et la réparation
AVIS: L'étiquette du ministère des Communications du Canada identifie Ie
matériel homologué. Cette étiquette certifie que Ie matériel est conforme à
certaines normes de protection, d'exploitation et de sécurité des réseaux de
télécommunications. Le Ministère n'assure toutefois pas que Ie matériel
fonctionnera à la satisfaction de I'utilisateur.
Avant d'installer ce matériel, I'utilisateur doit s'assurer qu'il est permis de Ie
raccorder aux installations de I'entreprise locale de télécommunication.
xiv
Customer Support Information
Le

Advertisement

Table of Contents
loading

Table of Contents