Creating A Gradation - Brother PE-Design 6.0 Instruction Manual

PeDesignV6Eng.book Page 179 Thursday, July 8, 2004 11:59 AM
Layout & Editing
Example 2
Stitch direction: 90°
Example 3
Stitch direction: 0°
c
"Previewing the Sewing Image" on
page 187 and "Programmable Stitch
Creator" on page 208
Editing Embroidery Patterns

Creating a gradation

The density of one or two colors can be adjusted at
various locations to create a custom gradation
pattern.
1.
In Expert mode of the Sewing Attribute
Setting dialog box, select the Gradation
check box under Region sew.
2.
Click Pattern.
→ The Gradation Pattern Setting dialog
box appears.
3.
To change the thread color, click
a color in the Thread Color dialog box that
appeared, and then click OK.
4.
To select a preset gradation pattern, click the
desired pattern under Select pattern.
5.
Move the sliders to adjust the density of the
gradation pattern.
b
Memo:
The preview area shows the setting changes
that you make.
6.
To blend two colors, select the Use additional
color check box, click
additional color. Select a color in the Thread
Color dialog box that appeared, and then click
OK.
7.
Click OK.
b
Memo:
• If the Use additional color check box is
cleared, the gradation settings are applied
to the remaining color.
• To close the dialog box without applying
the changes to the gradation pattern, click
Cancel.
. Select
under Use
179