System Requirements; [Step 1] Installing The Software - Brother PE-Design 6.0 Instruction Manual

PeDesignV6Eng.book Page 8 Thursday, July 8, 2004 11:59 AM

System requirements

Before installing the software on your computer, make sure that the computer meets the following
requirements.
Computer
Operating system
Processor
Memory
Hard disk free space
Monitor
Port
Printer
CD-ROM drive
a
Note:
• Power is supplied to the USB card writer module through the USB connection. Connect the USB card
writer module to a USB connector on the computer or to a self-powered USB hub that can supply
enough power to the card writer module. If the card writer module is not connected in this way, it may
not operate correctly.
• This product may not operate correctly with some computers and USB expansion cards.

[STEP 1] Installing the software

This section describes how to install the application software.
a
Note:
• If the installation is interrupted or not performed as described, the software will not be installed correctly.
• Before turning on the computer, be sure to DISCONNECT the USB card writer module.
b
Memo:
The following installation procedure includes descriptions and dialog boxes for Windows XP. The
procedure and dialog boxes for other operating systems may be slightly different.
1.
Insert the enclosed CD-ROM into the
computer's CD-ROM drive.
8
Before Use
IBM-PC or compatible computer originally equipped with a USB port
Windows 98, ME, XP or 2000
Pentium 500 MHz or higher
Minimum 64 MB (256 MB or more is recommended.)
Minimum 100 MB
SVGA (800 × 600), 16-bit color or higher
USB Ver. 1.1 or higher
A graphic printer that is supported by your system (if you wish to print your images)
Required for installation
→ After a short while, the Choose Setup
Language dialog box automatically ap-
pears.