5.
Connect the data cable to the hard drive (1) and to the system board (2).
Figure 4-58
6.
Connect the power cable (not shown).
Processor heatsink
This section describes how to remove and install a processor heatsink.
NOTE:
Not all heatsinks are the same. Therefore, the heatsink shown in the following figures is an
example of what might be installed in your workstation.
Removing the processor heatsink
To remove a heatsink:
1.
Power down the workstation
workstation
(Removing the side access panel on page
ENWW
Connecting the data cable
(Predisassembly procedures on page
(Predisassembly procedures on page
58), and then remove the side access panel
64).
Removing and replacing components 103
58), disconnect power from the