4 Replacement Procedures
4.14 LED board
Removing the LED board
The following describes the procedure for removing the LED board (See Figure 4-23).
1. Remove the following screw and LED board from the system board.
M2.5 6B
2. Disconnect the LED cable from the connector PJ9500 on the system board.
3. Disconnect the LED cable from the LED board.
M2.5 6B FLAT HEAD
4-40
FLAT HEAD screw
LED board
Figure 4-23 Removing the LED board
1
PJ9500
LED cable
Satellite A40 Maintenance Manual (960-458)
4.14 LED board