Toshiba Satellite A40 Maintenance Manual page 315

4.26 Fluorescent lamp
Attaching the tapes and insulation sheet
1. Attach the PCB insulation sheet (one point).
2. Attach the tape for the bezel to the bottom area close to the lamp (two points).
3. Attach the tape for fixing the FL tube cable (one point).
CAUTION: When attaching tape and insulation sheet, be careful not to damage the TAB
and lamp cable connections.
Attaching the insulation sheet
? ? ? ? ? ? ?? ?
1
Attach the sheet after removing slack.
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? .
The frame must not be
P C B? ? ? ? ? ?
overlaid with the PCB.
? ?? ? ? ? ? ? ?
? ? ? ? ? ? ? ? ? ? ? ?
Align the sheet with the reflector's
edge.
Align the sheet with the module's edge.
? ? ? ? ? ? ? ? ? ? ? ?
Figure 4-74 Replacing 14 Inch TMD fluorescent lamp (12)
Satellite A40 Maintenance Manual (960-458)
1
Align the sheet with the reflector's edge. ? ? ? ? ? ? ? ? ? ? ? ?
Align the sheet with the module's edge.
? ? ? ? ? ? ? ? ? ,
Attach the sheet by
? ? ? ? ?? ? .
pressing it so that the
bezel may not "fly".
2
2
? ? ? ? ? ? ? ? ? ? ? ? ?
The tape edge must not protrude
from the surface of the module.
Attaching the tape for the bezel
? ? ? ? ? ? ? ?? ?
Requirements for attachment:
The tape edge must not go
? ?? ? :
beyond the bezel's edge.
? ? ? ? ? ?? ? ? ? ?
4 Replacement Procedure
? ? ?? ? ? ? ? ? ? ? ?
The tape edge must not
protrude from the surface
? ? ? ? ? ? ? ? ? ? ? ? ?
of the module.
Requirements for attachment:
? ?? ? :
The tape edge must not go
? ? ? ? ?? ?? ? ? ? ?
beyond the module's edge.
? ? ? ? ? ? :
? ? ?? ? ?? ?? ?? Rubber cap: ? ? ?
Must cover the
opening for the cable.
5
ƒ
4-91