Toshiba Satellite A40 Maintenance Manual page 313

4.26 Fluorescent lamp
Setting the bezel
1. Start installing the bezel in the upward direction until it stops at the top left corner.
CAUTION: The GND-CU and lamp reflector on the left-hand side must not go beyond
the edges of the bezel.
Be careful not to damage the cables and TAB.
The bezel latches must be engaged (there are five latches on the top edge,
and two latches on the bottom edge).
Next, fit the bezel's edge
? ? ? T A B? ? ? ? ? .
? ? ? 5? ? ? ? ? ? .
close to the TAB.
Close the five latches.
G N D- C U? ?? ?? ? .
The fold of GND-CU must
? ? ? ? ? ? ? ? ? ? ? .
not go beyond the
The fold of reflector must not
go beyond the bezel's edge.
Figure 4-72 Replacing 14 Inch TMD fluorescent lamp (10)
Satellite A40 Maintenance Manual (960-458)
2
2
2
? ? ? ? ?? ?? ? ? ? .
? ? ? ? ? ? ? ? ? ? ?
4 Replacement Procedure
2
2
1
First, fit the bezel's edge close to the
? ? ? ? ? ? ? ? ? ? ? ? ? .
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?
lamp. Use care not to damage the
cable.
? ? ? 2? ? ? ? .
Two latches
4-89