4.26 Fluorescent lamp
4. Stick the outside tape and install the cover shield.
1) Stick the tape shield and adhesive tape to fix the top case.
NOTE: Be careful not to apply excessive force to the top case.
2) Install the cover shield (C).
NOTE: Be careful not to apply excessive force to the control PCB.
CAUTION: Wear anti-static gloves to prevent circuit damage to the source PCB.
3) Install the cover shield (G).
NOTE: Be careful not to apply excessive force to the gate TCP.
4) Stick the adhesive tape to fix the B/L wire.
NOTE: Be careful not to apply excessive force to the B/L wire.
Adhesive tape
Figure 4-88 Replacing 15.0 Inch LG.Philips fluorescent lamp (XGA) (8)
Satellite A40 Maintenance Manual (960-458)
Cover shield (C)
A d h e s i v e t a p e
Tape shield
4 Replacement Procedures
Cover shield (G)
4-107