Toshiba Satellite A40 Maintenance Manual page 258

4.12 Display assembly
Installing the Display assembly
To install the display assembly, follow the steps below and refer to figures 4-19 to 4-21.
1. Install the display assembly on the base assembly.
NOTE: When installing the display assembly, be careful not to pinch or damage any
cables.
2. Press along the edges of the display assembly to secure the latches.
3. Connect the panel sensor cable to the connector PJ3302 on the system board.
4. Connect the speaker cables to the connectors PJ6001 (blue) and PJ6002 (red) on the
system board.
5. Connect the LCD cable to the connector PJ5600 on the system board.
6. Secure the display assembly with the following screws .
M2.5 6B
7. Turn the computer face down and secure the display assembly with the following screws .
M2.5 16B
M2.5 6B
M2.5 3B
Satellite A40 Maintenance Manual (960-458)
FLAT HEAD screw
FLAT HEAD screw
FLAT HEAD screw
S-FLAT HEAD screw
4 Replacement Procedures
2
12 ("16" in the figure below)
7 ("6" in the figure below)
5 ("3" in the figure below)
4-37