Using The Mp Command Menu; Using The Efi Shell; Using Microsoft Windows Commands - HP Rx2620-2 - Integrity - 0 MB RAM Manual

Using the MP Command menu

The MP provides the following commands, available from the Command menu, to support boot
and reset operations:
Reset an nPartition. Reset an nPartition only after all self-tests and partition rendezvous
RS
have completed.
Perform a shutdown for reconfig of an nPartition. Reset an nPartition only after all self-tests
RR
and partition rendezvous have completed.
Boot the cells assigned to an nPartition past the waiting at BIBstate and begin the nPartition
BO
boot phase.
Perform a transfer of control reset of an nPartition.
TC
Power on or power off a cabinet, cell, or I/O chassis. On HP Integrity mid-range servers,
PE
nPartition power on and power off also is supported to manage power of all cells and I/O
chassis assigned to the nPartition using a single command.

Using the EFI Shell

EFI Shell provides the following commands to support boot and reset operations:
bcfg
autoboot
acpiconfig
acpiconfig enable
softpowerdown
acpiconfig disable
softpowerdown
reset
reconfigreset

Using Microsoft Windows commands

Microsoft Windows includes the following commands for shutting down and rebooting an
nPartition:
shutdown /r
28 Introduction
Lists and configures the boot options list for the local
nPartition.
Lists, enables, or disables the nPartition autoboot
configuration value.
Lists and configures the nPartition ACPI configuration
setting, which determines whether HP-UX, Windows, or
Linux can boot on the nPartition.
To boot Windows Server 2003, you must set the ACPI
configuration setting for the nPartition to windows.
When set, causes nPartition hardware to be powered off
when the operating system issues a shutdown for reconfig
command. On mid-range servers with a windows ACPI
configuration setting, this is the default behavior. This
command is available only on mid-range servers.
When set, causes nPartition cells to remain at BIB when
the operating system issues a shutdown for reconfig
command. In this case an operating system shutdown for
reconfig makes the nPartition inactive. This command is
available only on mid-range servers.
Resets the local nPartition, resetting all cells and then
proceeding with the nPartition boot phase.
Performs a shutdown for reconfig of the local nPartition,
resetting all cells and then holding them at the wait at BIB
state, making the nPartition inactive.
Shuts down Windows and performs a reboot for reconfig of the nPartition.
All cells are reset and nPartition reconfiguration occurs as needed. The
nPartition then proceeds with the nPartition boot phase.