Create A Genesis Partition - HP Rx2620-2 - Integrity - 0 MB RAM Manual

3. After you initiate the TOC, you can observe its progress and select the type of crash dump
through the nPartition console.
When the nPartition completes the dump, or when you cancel it, the nPartition reboots.
r00/03 00000000 00000000 00000000 0099CA2C 00000000 00000000 00000000 010BB790
r04/07 00000000 00000002 00000000 010BC140 00000000 0080F000 00000000 00AA2490
r08/11 00000000 00000001 00000000 0099A800 00000000 0099A800 00000000 0099C800
....
Processor 8 TOC:
Boot device reset done.
*** The dump will be a SELECTIVE dump:
*** To change this dump type, press any key within 10 seconds.
*** Proceeding with selective dump.
*** The dump may be aborted at any time by pressing ESC.
*** Dumping:

Create a Genesis Partition

Creating a Genesis Partition overwrites all nPartition-related complex profile data for the server
and establishes one single-cell nPartition.
As a result of this procedure, all existing nPartition configurations are deleted and are replaced
with a single, one-cell nPartition (the Genesis Partition).
You can revert to the previous nPartition configuration—if any existed before you created the
Genesis Partition—by using the CC command and L option to restore the last configuration.
Procedure 4-29 Creating a Genesis Partition [management processor]
To use the MP Command menu to create a Genesis Partition on an HP nPartition server, do the
following:
1. Save all current nPartition configuration details, if any nPartitions are configured in the
complex.
Saving the current nPartition information provides you with information you need to
re-create all nPartitions as they currently exist.
For each nPartition, enter the parstatus -V -p# command to display detailed information
about the partition number (-p#) specified and to save configuration details about each
nPartition.
2. Determine which cell to configure as the Genesis Partition.
The cell must be connected to an I/O chassis. The I/O chassis must have a core I/O card
installed, and it should have a bootable disk (or a method for installing an operating system
and a disk onto which it can be installed).
3. Ensure that all nPartitions within the complex are in the shutdown for reconfig (inactive)
state by using the RR command at the MP Command menu.
4. Log in to the MP for the server complex as a user with administrator privileges, which are
required for creating a Genesis Partition.
5. Enter CM to access the MP Command menu.
6. Issue the CC command, enter G for Genesis Complex Profile, and specify the cabinet and
cell slot for the cell that will become the Genesis Partition.
GSP:CM> CC
This command allows you to change the complex profile.
******* Unexpected TOC. Processor HPA FFFFFFFF FC07C000 *******
pcsq.pcoq = 0 0.0 12675c
isr.ior
7% complete (32 of 457 MB) (device 64:0x2)
GENERAL REGISTERS:
= 0 10340004.0 2f8bfd30
457 of 4080 megabytes.
nPartition-level tasks 63