HP Rx2620-2 - Integrity - 0 MB RAM Manual page 94

Option
-b path
-t path
-s path
-T flag
-P PartitionName
-k s_lock
-B
-u username:[passwd]
-g [passwd]
-h IPaddress|hostname
94 nPartition Commands Reference
Description
Specifies the primary boot path.
NOTE:
For Windows nPartitions on HP Integrity servers, boot paths
cannot be viewed or set using nPartition commands. Use the EFI Boot
Manager or the Windowsbootcfgcommand to view/configure boot
paths for Windows nPartitions.
Specifies the alternate boot path.
NOTE: For Windows nPartitions on HP Integrity servers, boot paths
cannot be viewed or set using nPartition commands. Use the EFI Boot
Manager or the Windowsbootcfgcommand to view/configure boot
paths for Windows nPartitions.
Specifies the secondary boot path.
NOTE: For Windows nPartitions on HP Integrity servers, boot paths
cannot be viewed or set using nPartition commands. Use the EFI Boot
Manager or the Windowsbootcfgcommand to view/configure boot
paths for Windows nPartitions.
Specifies if Hyper-Threading should be enabled (only if cell supports
this feature). If this option is not specified the Hyper-Threading
property will not be changed.
The valid values for flag are:
• y: Enables Hyper-Threading allowing multiple threads to run at
the same time on each CPU.
• n: Disables Hyper-Threading (the default)
Specifies the name of the nPartition.
Specifies the lock keys for the Stable Complex Configuration Data and
Partition Configuration Data provided by other system management
tools that invoke this command programmatically. Command line
users should avoid this option.
Specifies whether to boot the nPartition. The default is not to boot.
When you modify an inactive nPartition and specify the -B option,
the nPartition is booted (and becomes active) immediately after it is
modified.
When you modify an active nPartition and specify the -B option, you
must perform a reboot for reconfig of the modified nPartition. You
must perform this reboot for reconfig before any other cell assignments
can take place in the server complex.
Specifies the account and authorization to access an nPartition other
than the local nPartition.
The -h option is required if this option is used.
• username specifies a configured user name on the target nPartition.
• passwd specifies the password associated with the username. If this
field is empty, the command prompts for the password.
Allows access to the complex specified by the -h option. The accessed
complex is then considered the target complex. Access is through the
MP LAN port. The -h option is required if this option is used.
passwd specifies the IPMI password of the MP. If this field is omitted,
the command prompts for the password.
This option is only used in combination with either the -u or -g option.
IPaddress|hostname specifies the IP address or hostname of the target
nPartition (-u) or MP (-g).