HP Rx2620-2 - Integrity - 0 MB RAM Manual page 101

Integrity servers with microsoft windows server 2003
Hide thumbs Also See for Rx2620-2 - Integrity - 0 MB RAM:
Table of Contents

Advertisement

Options
Option
-f
-o
-B
-c cell
-i IOchassis
-I IOchassis
-b cabinet
-C
-l cabinet
-u username:[passwd]
-g [passwd]
-h IPaddress|hostname
Example
In the following example, you connect to the server's management processor (MP) from your
management station. The MP IP number is 192.168.24.68, and the MP password is "password".
Since you are connecting remotely using IPMI over LAN, you must include the -h... -g...
options with each command.
You want to find the core cell in nPartition #3 ("Frodo") so you can add more memory to it. But
you're not sure which cell is the core, or where it's located in the cabinet.
You use the parstatus command first (with the -P option) to find out which cell is the core.
Then you use the fruled command to turn off all cell indicator LEDs in the complex (-C option).
Then you use the fruled command again to make the LEDs blink on the target cabinet and the
cell itself (-B and -c options).
1.
Open a command window on the management station (Start > Run >entercmd >click OK).
2.
At the command prompt, enter the following: parstatus -h 192.168.24.68 -g
password -P and press Enter.
Description
Turn off specified attention LEDs. This is the default.
The -f and -o options are mutually exclusive.
Start blinking the specified attention LEDs. The -o option is unavailable with -C or -I.
Start or stop blinking the cabinet number LCD of the cabinet that contains the cell or
I/O chassis.
The -B option is only available with -c and -i.
link or turn off the specified cell attention LED.
cell can be specified either in the local (cabinet/slot) or global (cell_ID) format.
Blink or turn off the specified IOchassis attention LED.
Turn off all IOchassis LEDs.
Start or stop blinking the cabinet number LCD of the specified cabinet.
Turn off all cell attention LEDs.
Limit the scope of the -C or -I option to a given cabinet.
Specifies the account and authorization to access an nPartition other than the local
nPartition.
The -h option is required if this option is used.
• username specifies a configured user name on the target nPartition.
• passwd specifies the password associated with the username. If this field is empty, the
command prompts for the password.
Allows access to the complex specified by the -h option. The accessed complex is then
considered the target complex. Access is through the MP LAN port.The -h option is
required if this option is used.
passwd specifies the IPMI password of the MP. If this field is omitted, the command
prompts for the password.
This option is only used in combination with either the -u or -g option.
IPaddress|hostname specifies the IP address or hostname of the target nPartition (-u) or
MP (-g).
fruled
101

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bl860cNpartition

Table of Contents