List Memory Configurations; Configure Boot Paths And Options - HP Rx2620-2 - Integrity - 0 MB RAM Manual

2. From the command line, issue the parstatus -w command to list the local nPartition
number.
NOTE:
commands (-h and -g for IPMI over LAN connections; -h and -u for WBEM/WMI
connections). For a complete explanation of these options, see the command description in
"nPartition Commands Reference" (page

List memory configurations

Memory configuration details include summaries of the total memory in a cell or nPartition, the
amounts of interleaved memory and cell local memory (where supported) per cell or nPartition,
and the number and locations of memory modules (DIMMs) within the cells in a server complex.
Procedure 4-8 Listing memory configurations [nPartition commands]
List memory configurations using the following procedure:
1. Log in to Windows on the management station PC.
2. From the command line, issue the following command to list memory details:
• parstatus -C — Cell and memory summaries for all cells in the server complex.
• parstatus -V -c# — Detailed memory information for the specified cell (-c#, where
# is the cell number), including memory module (DIMM) locations and sizes. For HP
Integrity servers, this includes details about the interleaved memory in the cell as well
as the requested and allocated cell local memory (CLM) amounts.
• parstatus -V -p# — Detailed information about the specified nPartition (-p#, where
# is the nPartition number), with summaries for all assigned cells including their amounts
of memory. For HP Integrity servers, the nPartition details include the total good memory
size, total interleaved memory, and the total requested and allocated cell local memory
(CLM) amounts.
NOTE:
commands (-h and -g for IPMI over LAN connections; -h and -u for WBEM/WMI
connections). For a complete explanation of these options, see the command description in
"nPartition Commands Reference" (page

Configure boot paths and options

CAUTION:
to an IO chassis (rather than the core IO card), you must run the "search all" command from the
EFI prompt any time the partition is reset (for example, using the MP RS command). Otherwise,
the boot drive will not be found when the partition boots.
IMPORTANT:
using the MSUtil\nvrboot.efi utility to import boot options from the
EFI\Microsoft\WINNT50\Boot00... file on the device from which Windows is to be loaded.
Configure boot paths and boot options using any of the following procedures:
Procedure 4-9 Configuring boot paths and options [EFI Boot Manager]
Configure boot paths and options using EFI Boot Manager as follows:
48 Using Other Tools to Manage nPartitions
You must include the correct remote administration options when issuing par
You must include the correct remote administration options when issuing nPartitions
With HP Integrity mid-range systems, if Windows is installed on a drive attached
On HP Integrity servers, you must configure Windows boot options from EFI by
89).
89).