Fruled - HP Rx2620-2 - Integrity - 0 MB RAM Manual

Options
Option
-p PartitionNumber
-d
-s
-ccell
-P
-A
-u username:[passwd]
-g [passwd]
-h IPaddress|hostname

fruled

The fruled command blinks hardware attention indicators (LEDs) or turns them off.
This command can control the cell attention LEDs in all HP nPartition servers, as well as the I/O
chassis LEDs on Superdome servers. The fruled command also can start and stop blinking the
cabinet number LCDs on HP Superdome compute cabinets and I/O expansion cabinets.
Synopsis
fruled [-f|-o] [-B] -c cell [-c...]
fruled [-f|-o] [-B] -i IOchassis [-i...]
fruled [-f|-o] -b cabinet [-b...]
fruled [-f] -C [-l cabinet] [-l...]
fruled [-f] -I [-l cabinet] [-l...]
• The -h... -g... options must be specified to cause the command to send its management
request using IPMI over LAN to a MP in another server complex (but can also be used as a
"loopback access" to the MP in the local complex).
• The -h... -u... set of options must be specified to cause the command to send its
management request using WBEM to an nPartition other than the local nPartition (but can
also be used as a "loopback access" to the local nPartition).
The -g and -u options are mutually exclusive.
100 nPartition Commands Reference
Description
Unlock the Partition Configuration Data of the specified nPartition.
Unlocks the Dynamic Complex Configuration Data of the target complex.
Unlocks the Stable Complex Configuration Data of the target complex.
Unlocks the cell data of the specified cell.
Cancels any pending changes to the Stable Complex Configuration Data of the target
complex.
Unlocks the Complex Configuration Data, the Dynamic Complex Configuration Data, and
the Partition Configuration Data of all the nPartitions in the target complex.
Specifies the account and authorization to access an nPartition other than the local nPartition.
The -h option is required if this option is used.
• username specifies a configured user name on the target nPartition.
• passwd specifies the password associated with the username. If this field is empty, the
command prompts for the password.
Allows access to the complex specified by the -h option. The accessed complex is then
considered the target complex. Access is through the MP LAN port.The -h option is required
if this option is used.
passwd specifies the IPMI password of the MP. If this field is omitted, the command prompts
for the password.
This option is only used in combination with either the -u or -g option. IPaddress|hostname
specifies the IP address or hostname of the target nPartition (-u) or MP (-g).