Booting And Resetting Npartitions - HP Rx2620-2 - Integrity - 0 MB RAM Manual

Modifying nPartitions includes the following tasks:
• Assign (add) or unassign (remove) cells from an nPartition:
— In the Partition Manager Hardware tab, select the desired nPartition and cell and then
select nPartition > Assign cell(s) / Cell > Assign cell(s) or nPartition > Unassign
cell(s) / Cell > Unassign cell(s).
— Alternatively, use the parmodify -p# -a#... command to add a cell or the
parmodify -p# -d#... command to remove a cell from the specified nPartition
(-p#, where # is the partition number).
• Remove (delete) an nPartition:
— Shut down all open applications on the target nPartition. Shut down Windows on the
target nPartition. In the Partition Manager Hardware tab, select the desired nPartition
and then select nPartition > Delete nPartition.
— Alternatively, use the parremove -p# command to remove a specified nPartition (-p#,
where # is the partition number).
• Renaming an nPartition:
— In the Partition Manager Hardware tab, select the desired nPartition and then select
nPartition > Modify nPartition. In the General tab, enter a new name in the nPartition
Name text box and click OK.
— Alternatively, use the parmodify -p# -P name command to set the name for a
specified nPartition (-p#, where # is the partition number).
• Setting cell attributes:
— In the Partition Manager Hardware tab, select the nPartition that the target cell belongs
to. Select nPartition > Modify nPartition. Click the Set Cell Options tab, change the
Use On Next Boot attribute as desired, and click OK.
— Alternatively, use the parmodify -p# -m#... command to modify cell attributes
for a specified nPartition (-p#, where # is the partition number), or use the EFI Shell
cellconfig command to set use-on-next-boot values.
• Setting core cell choices:
— In the Partition Manager Hardware tab, select the nPartition that the target cell belongs
to. Select nPartition > Modify nPartition. Click the Set Cell Options tab, change the
Core Cell Choice attribute as desired, and click OK.
— Alternatively, use the parmodify -p# -r# -r#... command to specify up to four
core cell choices in priority order for a specified nPartition (-p#, where # is the partition
number), or use the EFI Shell rootcell command to set core cell choices.
• Setting cell local memory (vs. interleaved memory) values:
— In the Partition Manager Hardware tab, select the nPartition that the target cell belongs
to. Then select nPartition > Modify nPartition. Click the Configure Memory tab, change
the Requested CLM attribute as desired (either as a fraction of total available memory,
or as a fixed amount), and click OK.
— Alternatively, use the parmodify -p# -m#::::%command (-p#, where # is the
partition number, and -m#, where # is the cell number and % is the desired cell local
memory value, expressed as a percentage).
• Setting nPartition boot paths:
— You must use the EFI Shell bcfg command to configure boot paths.

Booting and resetting nPartitions

This section lists the main nPartition boot commands and tasks.
Performing nPartition management tasks 27