Cplxmodify - HP Rx2620-2 - Integrity - 0 MB RAM Manual

2. At the command prompt, enter the following: frupower -h 192.168.24.68 -g
password -C and press Enter.
The sequence of commands and results is shown here:
C:\>frupower -h 192.168.24.68 -g password -C
Note: The -g option may require up to 2 minutes to complete. Please wait...
Global cell 0; cabinet 0, cell 0 is powered off.
Global cell 1; cabinet 0, cell 1 is powered on.
Global cell 2; cabinet 0, cell 2 is powered on.
Global cell 3; cabinet 0, cell 3 is powered on.
Global cell 4; cabinet 0, cell 4 is powered on.
Global cell 5; cabinet 0, cell 5 is powered on.
Global cell 6; cabinet 0, cell 6 is powered on.
Global cell 7; cabinet 0, cell 7 is powered on.
Global cell 8; cabinet 1, cell 0 is powered on.
Global cell 9; cabinet 1, cell 1 is powered on.
Global cell 10; cabinet 1, cell 2 is powered on.
Global cell 11; cabinet 1, cell 3 is powered off.
Global cell 12; cabinet 1, cell 4 is powered on.
Global cell 13; cabinet 1, cell 5 is powered on.
Global cell 14; cabinet 1, cell 6 is powered on.
Global cell 15; cabinet 1, cell 7 is powered on.

cplxmodify

The cplxmodify command modifies attributes of an nPartition-capable server complex, such
as the complex name.
Root permission is required to run this command.
Synopsis
cplxmodify -N ComplexName [ -u username:[passwd] -h IPaddress|hostname | -g [passwd] -h
IPaddress|hostname ]
• The -h... -g... options must be specified to cause the command to send its management
request using IPMI over LAN to a MP in another server complex (but can also be used as a
"loopback access" to the MP in the local complex).
• The -h... -u... set of options must be specified to cause the command to send its
management request using WBEM to an nPartition other than the local nPartition (but can
also be used as a "loopback access" to the local nPartition).
The -g and -u options are mutually exclusive.
Options
Option
-N ComplexName
-u username:[passwd]
104 nPartition Commands Reference
Description
Changes the name of the target complex to ComplexName.
Specifies the account and authorization to access an nPartition other than the local
nPartition.
The -h option is required if this option is used.
• username specifies a configured user name on the target nPartition.
• passwd specifies the password associated with the username. If this field is empty, the
command prompts for the password.