Table 5.66
Start NVRAM Diagnostic
Convention
MegaCli –AdpNVRAM {-Read|-Write -ffilename}|–Clear
[-StartOffset 0xXXXX] [-EndOffset 0xXXXX] aN
Description
Starts the NVRAM diagnostic.
-Read: Reads the content in NVRAM and writes the data to file filename.
-Write: Reads data from file filename and writes to NVRAM.
-Clear: Writes 0 to NVRAM at the specified range from start offset to end offset.
-StartOffset/-EndOffset: Specifies the start offset and/or end offset in NVRAM.
If you do not use the -StartOffset and -EndOffset options, the default
StartOffset is 0 and the default EndOffset is the end of actual NVRAM size.
5.16 Miscellaneous Options
5.16.1
Display the MegaCLI Version
Table 5.67
Display MegaCLI Version
Convention
MegaCli –v
Description
Displays the version number of the MegaCLI utility.
5.16.2
Display Help for MegaCLI
Table 5.68
Display Help for MegaCLI
Convention
MegaCli –h|–Help|?
Description
Displays help for the MegaCLI utility.
5-38
The commands in this section are used to display various information.
Use the command in
MegaCLI utility.
Use the command in
MegaCLI utility.
MegaRAID Command Tool
Table 5.67
to display the version number of the
Table 5.68
to display help information for the