Options For Displaying Logs Kept At Firmware Level; Event Log Management - Lenovo ThinkServer RD240 Software User's Manual

Table 5.24 Set BBU Properties
Convention
MegaCli -AdpBbuCmd -SetBbuProperties -f<fileName> -aN|-a0,1,2|-aALL
Description Sets the BBU properties on the selected controller(s) after reading from the file.
The information displays in the following formats:
autoLearnPeriod = 1800Sec
nextLearnTime = 12345678Sec Seconds past 1/1/2000
learnDelayInterval = 24hours Not greater than 7 days
autoLearnMode = 0 0 – Enabled, 1 - Disabled, 2 – WarnViaEvent.
1. NOTE: You can change only two of these parameters, learnDelayInterval and
5.8

Options for Displaying Logs Kept at Firmware Level

5.8.1

Event Log Management

Table 5.25 Event Log Management
Convention
MegaCli –AdpEventLog –GetEventlogInfo | –GetEvents {-info -warning -
critical -fatal} | GetSinceShutdown {-info -warning -critical -fatal}
| GetSinceReboot {-info -warning -critical -fatal} | IncludeDeleted
{-info -warning -critical -fatal} | {GetLatest <number> {-info -
warning -critical -fatal} } -f <filename> | Clear -aN|-a0,1,2|-aALL
| {GetCCIncon} -f <filename> -LX| -L0,2,5...|-LALL -aN|-a0,1,2|-aALL
5-18
autoLearnMode.
Use the commands in this section to select the display settings for the
event log and BBU terminal log, which are kept at the firmware level.
Use the command in
log for the selected controller(s).
MegaRAID Command Tool
Table 5.25 to manage the event entries in the event