Set Bbu Terminal Logging; Configuration-Related Options - Lenovo ThinkServer RD240 Software User's Manual

Table 5.25 Event Log Management (Cont.)
Description Manages event log entries. The following are the settings you can select on a single
controller, multiple controllers, or all controllers:
-GetEventlogInfo: Displays overall event information such as total number of
events, newest sequence number, oldest sequence number, shutdown sequence
number, reboot sequence number, and clear sequence number.
-GetEvents: Gets event log entry details. The information shown consists of total
number of entries available at firmware side since the last clear and details of each
entries of the error log. Start_entry specifies the initial event log entry when
displaying the log.
-GetSinceShutdown: Displays all of the events since last controller shutdown.
-GetSinceReboot: Displays all of the events since last controller reboot.
-IncludeDeleted: Displays all events, including deleted events.
-GetLatest: Displays the latest number of events, if any exist. The event data will
be writtent to the file in reverse order.
-Clear: Clears the event log for the selected controller(s).
-GetCCIncon:
5.8.2

Set BBU Terminal Logging

Table 5.26 Set BBU Terminal Logging
Convention
MegaCli –FwTermLog -Bbuoff |–BbuoffTemp|-Bbuon|-BbuGet|-Dsply | -Clear
-aN| -a0,1,2|-aALL
Description Sets BBU terminal logging options. The following are the settings you can select on
a single controller, multiple controllers, or all controllers:
-Bbuoff: Turns off the BBU for firmware terminal logging. To turn off the BBU for
logging, you have to shut down your system or turn off the power to the system after
you run the command.
–BbuoffTemp: Temporarily turns off the BBU for TTY (firmware terminal) logging.
The battery will be turned on at the next reboot.
-Bbuon: Turns on the BBU for TTY (firmware terminal) logging.
-BbuGet: Displays the current BBU settings for TTY logging.
-Dsply: Displays the TTY log (firmware terminal log) entries with details on the
given controllers. The information shown consists of the total number of entries
available at a firmware side.
-Clear: Clears the TTY log.
5.9

Configuration-Related Options

Use the command in
selected controller(s).
You can specify the drives by using the Enclosure ID:Slot ID for SAS
controllers. This assumes that all drives are connected to the controller
through an enclosure. If the drives are not connected to an enclosure, it
Configuration-Related Options
Table 5.26 to set the BBU terminal logging for the
5-19