5.1
Product Overview
5-2
•
Section 5.12, "Enclosure-Related Options"
•
Section 5.13, "Flashing the Firmware"
•
Section 5.14, "SAS Topology"
•
Section 5.15, "Diagnostic-Related Options"
•
Section 5.16, "Miscellaneous Options"
The MegaCLI Configuration Utility is a command line interface
application you can use to manage MegaRAID SAS RAID controllers.
You can use MegaCLI Configuration Utility to perform the following tasks:
•
Configure MegaRAID SAS RAID controllers and attached devices
•
Display information about virtual drives and drives for the controller
and other storage components
•
Display ongoing progress for operations on drives and virtual drives
•
Change properties for the virtual drives and drives for the controller
and other storage components
•
Set, retrieve, and verify controller default settings
•
Change the firmware on the controllers
•
Monitor the RAID storage systems
•
Support RAID levels 0, 1, 5, 6, 10, 50, and 60 (depending on the
RAID controller)
•
Create and use scripts with the scriptable CLI tool
•
Configure drive into groups and virtual drives on the controller
•
Display configuration information for the controller, drives, and virtual
drives
•
Change virtual drive properties on the controller
•
Change drive properties on the controller
•
Display controller properties
•
Load configuration to the controller from a file
•
Save the controller configuration to a file
MegaRAID Command Tool