Linux Error Messages - Lenovo ThinkServer RD240 Software User's Manual

6.3.3

Linux Error Messages

not list any servers. You can use this screen to manage systems
remotely.
To install the software using interactive mode, execute the command
./install.sh from the installation disk.
To install the product in a non-interactive or silent mode, use the
command ./install.sh [-options] [ -ru popup] from the
installation disk. The installation options are:
– Complete installation
– Client Component Only
– StandAlone
The -ru popup command will remove popup from installation list.
You can also run non-interactive installation using the RunRPM.sh
command.
The installer offers three types of setup options:
1. Complete - This installs all the features of the product.
2. Client Components Only - The storelib feature of the product are not
installed in this type of installation. As a result, the resident system
can only administer and configure all of the servers in the subnet,
but it cannot serve as a server.
3. StandAlone - Only the networking feature is not installed in this case,
so the resident system is not a part of the network. This means the
system cannot browse any other MSM servers in the subnet, and the
MSM servers cannot will recognize it as a server.
This installation helps you select any of the setup types, but if you run
RunRPM.sh, it installs the complete feature.
The following messages may appear while you are installing MegaRAID
Storage Manager software on a Linux system:
•
More than one copy of MegaRAID Storage Manager software has
been installed.
Installing MegaRAID Storage Manager
.
6-9