Bootable Virtual Drive Id; Set Or Display Bootable Virtual Drive Id; Options For Bios Status; Battery Backup Unit-Related Properties - Lenovo ThinkServer RD240 Software User's Manual

5.6.1

Set or Display Bootable Virtual Drive ID

Table 5.15

Bootable Virtual Drive ID

Convention
MegaCli –AdpBootDrive {-Set –Lx| -physdrv[E0:S0]}} | -Get -aN|-
a0,1,2|-aALL
Description Sets or displays the bootable virtual drive ID:
-Set: Sets the virtual drive as bootable so that during the next reboot, the BIOS will
look for a boot sector in the specified virtual drive. Identifies the physical drive in the
virtual drive, by enclosure and slot, to use to boot from.
-Get: Displays the bootable virtual drive ID.
5.6.2 Select BIOS Status Options
Table 5.16

Options for BIOS Status

Convention
MegaCli –AdpBIOS -Enbl|-Dsbl|-Dsply| SOE | BE
Description Sets BIOS options. The following are the settings you can select on a single
controller, multiple controllers, or all controllers:
-Enbl, -Dsbl, -Dsply: Enables, disables or displays the BIOS status on selected
controller(s).
-SOE: Stops on BIOS errors during POST for selected controller(s). When set to
-SOE, the BIOS stops in case of a problem with the configuration. This gives you the
option to enter the configuration utility to resolve the problem. This is available only
when you enable the BIOS status.
-BE: Bypasses BIOS errors during POST. This is available only when you enable the
BIOS status.
5.7

Battery Backup Unit-Related Properties

Use the command in
virtual drive.
Note: This option does not write a boot sector to the virtual drive.
The operating system will not load if the boot sector is
incorrect.
Use the command in
You can use the commands in this section to select the settings for
BBU-related options.
Battery Backup Unit-Related Properties
Table 5.15 to set or display the ID of the bootable
Table 5.16 to set the options for the BIOS status.
-aN|-a0,1,2|-aALL
5-13