Lenovo ThinkServer RD240 Software User's Manual page 171

Chapter 5
MegaRAID Command
Tool
The MegaRAID Command Tool (CT) is a command line interface (CLI)
application for SAS. You can use this utility to configure, monitor, and
maintain MegaRAID SAS RAID controllers and the devices connected to
them.
Note: The CT supports only the MegaRAID controller. It supports
SAS and SATA II, but it does not support other types of
MegaRAID controllers, such as U320, SATA I, or IDE.
Note: The IA-64 release for Windows® is similar to the 32-bit
release, so you can follow the 32-bit instructions. 32-bit
applications that were validated on an x64 system, such as
the Intel® Markette system, can use the 32-bit instructions,
also.
This chapter has the following sections:
•
Section 5.1, "Product Overview"
•
Section 5.2, "Novell NetWare, SCO, Solaris, FreeBSD, and DOS
Operating System Support"
•
Section 5.3, "Command Line Abbreviations and Conventions"
•
Section 5.4, "Controller Property-Related Options"
•
Section 5.5, "Patrol Read-Related Controller Properties"
•
Section 5.6, "BIOS-Related Properties"
•
Section 5.7, "Battery Backup Unit-Related Properties"
•
Section 5.8, "Options for Displaying Logs Kept at Firmware Level"
•
Section 5.9, "Configuration-Related Options"
•
Section 5.10, "Virtual Drive-Related Options"
•
Section 5.11, "Drive-Related Options"
MegaRAID SAS Software User Guide 5-1