Power Supply Status Leds - HP AA979A - StorageWorks SAN Switch 2/8V Installation Manual

Table 20 SAN Switch 4/32 nonport side LEDs (continued)
Number
3
4
CAUTION:
regulatory certifications. There are no user-serviceable parts inside the power supply.
Table 21 describes the power supply status LEDs and corrective actions.
Table 21

Power supply status LEDs

LED behavior
No light
Steady green
Steady amber for more
than five seconds
Description
Power supply 1 status LED
Power supply 1
Disassembling any part of the power supply voids the part warranty and
Meaning
The power supply is not receiving
power or is off.
Power supply is operating normally.
Power supply fault for one of the
following reasons:
• Power cable is disconnected
•
Power supply is off
• Power supply has failed
SAN Switch 2/8V, 2/16V, 2/16N and 4/32 installation guide
.
Correction action
Verify that the power supply is on and
seated and that the power cord is
connected to a functioning power source.
No action required.
Try the following:
• Check the power cable connection.
•
Verify that the power supply is
powered on.
• Replace the power supply.
81