8.
Verify that a plenum is installed on the SAN Switch 2/8V, SAN Switch 2/16V or SAN
Switch 2/16N models only, as shown in
dissipates the heat generated by the switch, preventing overheating.
NOTE:
The plenum is a required part of this installation for SAN Switch 2/8V, SAN Switch
2/16V or 2/16N models only, when installed in HP 10,000 series, or System/e racks.
Figure 12
Securing the inner rails to the SAN Switch 2/8V with plenum
The components in
1
2
46
Installing and configuring
Table 12
include:
Plenum
Switch
Figure
12. The plenum is an overlay that
1
2
0013a