Installing The Switch In A Rack Using The San Switch Rack Mount Kit - HP AA979A - StorageWorks SAN Switch 2/8V Installation Manual

Installing the switch in a rack using the SAN
Switch Rack Mount Kit
This section provides instructions for installing the SAN Switch in an HP System/e rack, or in an
HP 10,000 series rack using the HP StorageWorks SAN Switch Rack Mount Kit supplied with
your switch.
Install the SAN Switch Rack Mount Kit in one of two ways:
• Allow the port side of the switch to slide out of the exhaust-air side of the rack.
• In this installation, the port side of the switch is flush with the edge of the rack.
• Allow the nonport side of the switch to slide out the cool-air side of the rack.
• In this installation, the port side of the switch is set 3 in. (7.62 cm.) back from the edge
of the rack, allowing a more gradual bend in the fiber optic cables.
NOTE: The SAN Switch Rack Mount Kit install requires one technician.
The following items are required to install the switch in a rack:
•
SAN Switch
• Power cables
• #2 Phillips screwdriver
• 7/16-inch wrench or socket
• SAN Switch Rack Mount Kit hardware, illustrated in
SAN Switch 2/8V, 2/16V, 2/16N and 4/32 installation guide
Table 7
37