SAN Switch 2/8V, 2/16V and 2/16N LED
patterns
Table
13,
Table 14
System and power LED patterns
The system and power LED patterns are shown in
Table 13
System LED patterns during normal operation
LED name,
LED color
location
System Status
No light
and Power
Status
Steady green
At right of
serial port on
bottom
Slow-flashing
green
(on 1 second,
off 1 second)
Amber
and
Table 15
summarize LED location, color, and recommended action.
Status of hardware
Switch is off, boot is not
complete, or boot failed.
Switch is on and power supplies
are functioning properly.
One or both of the following are
true:
One or more environmental
ranges are exceeded.
Error log contains one or more
port diagnostic error messages.
One failed power supply in the
SAN Switch 2/16V
SAN Switch 2/8V, 2/16V, 2/16N and 4/32 installation guide
Table
13.
Recommended action
Verify that switch is on and has
completed booting.
No action required.
Check environmental
conditions, error log, Port
Status LEDs, transceivers,
cables, and loopback plugs.
Correct error condition.
Clear error log.
Rerun diagnostics to verify fix.
No action required, but failure
of the remaining power supply
will cause the switch to fail.
67