Installing As A Stand-Alone Device - HP AA979A - StorageWorks SAN Switch 2/8V Installation Manual

Installing as a stand-alone device

Follow these steps to install as a stand-alone unit.
1. Unpack the switch and verify that all items listed on
on page 32 are present and undamaged.
2.
Locate the four rubber feet in the Accessory box.
3. Apply the adhesive rubber feet. Applying the rubber feet in the switch helps prevent the
switch from sliding off the supporting surface.
a. Clean the indentations at each corner of the bottom of the switch to ensure that they are
free of dust or other debris that might lessen the adhesion of the feet.
b. With the adhesive side against the chassis, place one rubber foot in each indentation
and press into place.
4. Place the switch on a flat, sturdy surface.
5.
Apply power to the switch as described in
CAUTION:
instructions on how to set the IP address, see
page 50.
36 Installing and configuring
Do not connect the switch to the network until the IP address is correctly set. For
"SAN Switch shipping carton
"Powering on and off" on page 62.
"Cabling and configuring the SAN
contents"
Switch" on